Blessed
are the Geeks, for they shall internet the earth
Cisco Router Tips Top 10 'show' Commands Tom Lancaster
One of the most important abilities a network administrator can have is the
know-how to get information out of his network devices so he can find out
what's going on with the network. In most networks, the staple of
information gathering has been the "show" commands. Here are my
top ten commands to know and love:
show version: Start simple; this command gives uptime, info
about your software and hardware and a few other details.
show ip interface brief: This command is great for showing
up/down status of your IP interfaces, as well as what the IP address is
of each interface. It's mostly useful for displaying critical info about
a lot of interfaces on one easy to read page.
show interface: This is the more popular version of the command
that shows detailed output of each interface. You'll usually want to
specify a single interface or you'll have to hit 'page down' a lot. This
command is useful because it shows traffic counters and also detailed
info about duplex and other link-specific goodies.
show ip interface: This often overlooked command is great for
all the configuration options that are set. These include the switching
mode, ACLs, header compression, ICMP redirection, accounting, NAT,
policy routing, security level, etc. Basically, this command tells you
how the interface is behaving.
show ip route: This indispensable command shows your routing
table, which is usually the primary purpose of the box. Get to know the
options on this command.
show arp: Can't ping a neighbor? Make sure you're getting an
arp entry.
show running-config: This is an easy one. It tells you how the
box is configured right now. Also, "show startup-config" will
tell you how the router will be configured after the next reboot.
show port: Similar to the show interface command on routers,
this command gives you the status of ports on a switch.
show vlan: With the trend toward having lots of VLANs, check
this command to make sure your ports are in the VLANs you think they
are. Its output is very well designed.
show tech-support: This command is great for collecting a lot
of info. It basically runs a whole bunch of other show commands, and
spits out dozens of pages of detailed output, designed to be sent to
technical support. But, it's also useful for other purposes.
SearchNetworking.com
is the largest and most active online community dedicated to the enterprise
network. Over 300,000 IT professionals rely on SearchNetworking.com
for industry news, technical tips and valuable best practices on routing,
switching, network security, network/systems management, convergence/VoIP
and wireless LANs, so they can keep their networks up to date and cope with
constant change.
Whether
you are looking for advice on implementing a new technology or seeking new
cost-saving strategies to improve the performance of your current network,
SearchNetworking.com is an online helpdesk for IT managers and
administrators. We provide unbiased news, a library of how-to tips,
informative learning guides, expert and vendor Webcasts and white papers –
all in an effort to arm you with the tools and tactics you need to do your
job successfully and make the right IT purchasing decisions. Register
for FREE today... http://searchnetworking.techtarget.com/registerProfile/1,291003,sid7,00.html
Disclaimer: The Opinions shared on
TheNetworkAdministrator.com are contributed by its readers and does not necessarily
express
the opinion of the creators of this publication.
One of the most important abilities a network administrator can have is the
know-how to get information out of his network devices so he can find out
what's going on with the network. In most networks, the staple of
information gathering has been the "show" commands. Here are my
top ten commands to know and love:
